RAMPS 1.4 Endstop Switch For RepRap Mendel 3D Printer With 70cm Cable

RAMPS 1.4 Endstop Switch For RepRap Mendel 3D Printer With 70cm Cable

$1.43

BUY | View Photos, Full Description, Latest Price.
  • Shown in your selected currency.
  • Non-USD prices are estimates based on current exchange rate.

Updated: 9 December, 2018

With 1.4 abutment pass Mendel RepRap 3D printer with 70cm Cable Features: This WIRES with internal copper wire 22 AWG is very Thick- be resistant to current 2A- voltage 300V. An insulating layer in a wide range temperatures- to 80 degrees. The total connection thin copper wire can not be compared. It is not easy to pull off the connector is convenient- the useful outlet face on the other side to make a single can use directly plugboard Size: approx. 39 x 16 x 7 mm / 1.54 x 0.63 x 0.28 inchCable length: ca .. 70 cm / 27,56 inchConnection Description: The red line, which connects the VCC (ramp) Connect the black wire GND ( ramp -) Connecting green line signal (ramp vs) recommendations for normal circumstances- system must be designed in such a way that at least three mechanical switches.

Store

Banggood

Brand

Geekcreit